Sugar coating machine

Sugar coating machine Details:
First, the use of the machine
    PG series of sugar machines, widely used in pharmaceutical, chemical, food, research institutes, hospitals, tablets, pills pack sugar, polishing and rolling food, can be used for new drug trial research institutes.
Coated polished candy and chocolate, with the appearance of bright color, the surface crystallization of sugar produced after the complete consolidation of cladding.
Second, the principle
1, the working principle
    As soon as possible to the chip evenly coated on its surface coated crystal, and polished to achieve the purpose, it must be by hand several times on the chip pan spray compound syrup add mix slurry. Clockwise through the pot, so sugar-coated tablet in the pot rolling, sliding friction and grinding it evenly on all chips. At the same time to the pot through the air, can quickly remove the tablet surface water, and finally get sugar coated tablets and other qualified products.
This series machine is the best sugar coating process equipment to the best pot, speed and stability to ensure the best tablet in the pot to form a logistics curve to meet the sugar-coated layer of uniform thickness, color and light pitting does not occur in the process requirements .
 
2, the structure
(1)exercise machine
    This series of one-way machine systems, low-speed continuous rotation of the coating equipment, the main motor through the belt drive - drive drive Worm pot rotation. 
(2) structure
    a, in the middle of the machine is equipped with hand wheel adjustment, need to adjust the sugar-coated pan for the tilt angle.
    B, using worm as the movement of the terminal output, with smooth operation, physical self-locking characteristics of the pot.
    C, hot air drying device using resistive wire heating, and is divided into high and low temperature switch, easy to control.
 
Third, the machine lubrication
    Bearings and worm gear box, worm with splash lubrication, at the top of the oil cup lubrication of a bearing, regularly filling the oil cup. Gearbox oil change once every six months in winter with HL20, HL30 gear oil for summer.
 
Fourth, installation and commissioning of the machine
    1, the machine must be placed in place stable and fixed with anchor bolts.
    2, open the grease on the gear box cover to add oil to the oil standard line.
    3, the electrical control box placed in the dry side for easy operation, power is on the line should be noted that sugar-coated pan for clockwise rotation.
    4, the test should pay attention to whether there were unusual noise machine to stop in time check.
    5, sugar pot and the object of inclination of load switching performance related. When installed with moderate amount of general, an inclination of 30o sugar pot, its production efficiency and quality are good.
 
Fifth, the machine's operating rules
    1, the operation must be carefully checked before each part of the machine for loose fasteners.
    2, the sugar scrub outside the pot
    3, start the main motor, running the machine empty for 2 minutes in order to determine whether the failure.
    4, after feeding the main motor should press the button, then under the crystallization of sugar required by the blower button, turn the heating wire switch.
 
VI, maintenance and safety technology
    1, the deceleration box should be in accordance with the requirements of the oil changed regularly.
    2, sugar pot, such as long-term need to be cleaned, the brass still in its pot coated with oil to prevent copper oxidation or moisture resulting from toxic copper compounds.
    3, to ensure the worm drive gear box lubrication conditions, the operation of the cabinet temperature not exceeding 50 °C.
    4, the worm shaft seals should be checked regularly replaced, usually not more than six months.
    5, the machine must be grounded, the grounding resistance should be ≤ 4Ω.
    6, shall not be removed of the electrical and belt guard.