ML1000 magnetostrictive level gauge with imported material

Carton

Specifications

 The product is designed and certificated according to the explosion-proof requirement  

 which applies to the accurately measurement of processing container and storage container.

Instrument survey

                                                            alloy                      stainless steel

transport damage or not.

Installation step:

1. Take off the flange from the testing hole of the oil container.

2.please insert the detector to the installation hole of the flange.

3. Please install the liquid floater, interface floater, and locking to the detector step by step;

4.please insert the detector to the measuring hole.

5.please take up the detector after putting the end of the container, for the distance is 2-10mm from the detector to the container end for protecting the bar to bending.

6. Then tightening the detector locknut and flange.

Installation diagram

(1) measuring blind area     

(2) Installation height

(3) Measuring range

(4) Actual liquid level

the instrument for the intrinsic type.

The power supply cable could use popular two-core cable,the outer diameter of

 the cable is 5...9mm for guaranteeing the seal of the cable entrance. If the

 electromagnetic interference exists, we suggest to use the shielding cable. Two

 terminal of the shielding cable should be earthing. The shielding must directly

connect inner earthing terminal. The outer terminal of the shell must be earthing. If

 having the earthing circuit, the shielding terminal of the instrument must be earthing

 through a ceramic capacity(such as 1µ F 1500V) to restrain the low-frequency

earthing circuit, and the prevent high-frequency interference signal at the same

 time.

PF PTFE soften cable detector, only for AT500-F

Installation mode:

LW top installation

MW side by side installation

TW end installation

Shell

A casting aluminum

S stainless steel

Process temperature

H1 -40-120°C

H1 -40-200°C

H2 -40-350°C

Output signal

M1 one liquid level HART Protocol

M2   interface level, one liquid level HART Protocol

M4   interface level, two liquid levels HART Protocol

/ Installation height(mm)

/measuring range(mm)

/medium density(g/cm)

/working pressure(MPa)