OD 22mm 5 Conductors Electrical Contacts Slip Ring Slip Ring Rotating Connector

Specifications

slip ring rotating connector

Description

Slip rings of the HM series are specially fit for small or miniature rotating system of transmitting low controlling signal.Applies noble precious metal reduced noises and interferences between circuits, low friction torque assures long life-span.

Models are available in 4, 6, 12, 18, 24, 30, 36, 46 and 56 circuits with 2A each.

Features

uCompact design

uNo maintenance

uOperating smoothly and reliability

uExtremely low electrical noise

uConvenient to assembly

uCompatible with data bus protocols

uPrecious metal contact ensures long life-span

Typical application

uElectrical test equipment

uManufacturing and process control equipment

uIndexing tables, Cable reels

uRobotics, rotary sensors, urgent illumination equipment

uExhibit / display equipment

uCCTV pan

uLaboratory equipment

uAviation, military, marine and medical equipment

uWind generator

Benefits

uCompact for ease of incorporation in small mechanisms.

uOutstanding signal handling capability to transfer the most demanding communication protocols

Option

uOperation speed, current &voltage

uConnector

uNo. of circuits

uHousing material

uPosition of wire outlet

uProtection level (dust and water)

uPower ring with 5A and 10A is available upon 2A rings combination

uCompatible with digital signal and analog signal such as RS series signal, data bus protocols, Ethernet signal and so on.

Installation Guide

1. Capsule slip ring is designed for being installed with flange on a sleeve bracket.
2. Rotor must be concentric driven by a flexible link (such as plastic tube or screw tube). Rotor lead wire can do as this driver at limited-speed.
3. As the photograph shows, screws with washer can be used to install slip ring, these washers can avoid flange too tight.

Attentions:

1. Slip ring can not support the weight of equipment which connects with it, rotating equipment should be fastened so that its weight will no fall on the rotor.
2. Slip ring should be used in dry, low dust environment. If used outdoor, shield is necessary.
3. The surface of lead wire should avoid being damaged while equipment rotating, all lead wire can not bear weight while you put the lead wire in order.
4. No damaging the surface of lead wire while barking its end.

Pack in carton or wooden case 

BY DHL, FedEx, UPS or TNT.......

We strive to meet the needs of our customers. If an assembly from above does not fit your requirements, our R&D team will work with you to design a slip ring to meet your exact demands.

Two years quality guarantee.