Paper Bale Black Annealed Wire

Specifications

Paper Bale Black Annealed Wire

Hard Drawn Low Carbon Wire has been cold drawn to the required diameter and heat treatment is available. Often used for plating, redrawing and coating, it is important that the surface finish of the wire is clean and smooth. It will take moderate bending or flattening, machine ability is fair and the wire can be roll threaded.

This is a general purpose manufacturing wire suitable for a large range of applications. Various applications include super market trolleys, shelving, baskets, racks, hooks and general automotive parts.

Additional Info

Diameter Range: 1.60-12.50 mm

Diameter Range: 1.90-12.50 mm

Diameter Range: 4.00-7.80 mm

Hard Drawn Low Carbon Wire Specifications

Diameter Properties

Hard Drawn Low Carbon Wire is manufactured to comply with the following diameter tolerances:

Tensile Strength (MPa)

The tensile strength is defined as the maximum load achieved in the tensile test, divided by the cross-sectional area of the wire test. The tensile strength developed depends on the amount of reduction in area to the finished size. Tensile is not considered of prime importance to this product however the following table is given as a general guide:

Steel Chemistry

OneSteel uses a variety of steel grades to manufacture its Hard Drawn Low Carbon range. The table below is indicative only of steel chemistries used.