RGB color changing LED under car ribbon 900mm x2 600x2 w/ remote control

This under car kit comes with 4pcs ultra bright LED strips 2 x 36" and 2 x 24". (2 x 90cm + 2 x60cm)

Wireless remote control is included.

This product is not just limited to vehicle use by any use which 12V power is available. For home decor or commercial applications, these LED under car kits are great! Since LED under car kits operate off of basic 12V DC, you simply have to power them with our LED power supply. With that said, installation can be anywhere a household plug is located. A great use of this product is behind frosted glass.

7 Colors:
The Colors include Red, Green, Blue
Yellow (Green+Red),
Magenta (Red+Blue),
Cyan (Blue+Green),
White (Red+Green+Blue)

Set one:

4PCS LED strip light packing in a gift box: 1 set = 4pcs as follows
2pcs of 36 inches (90cm) 54-LED waterproof LED strips
2pcs of 24 inches (60cm)36-LED waterproof LED strips
1pc of Control Receiver Box
1pc of remote controller

Set Two:

4PCS LED strip light packing in a gift box: 1 set = 4pcs as follows
2pcs of 48 inches (120cm) 72-LED waterproof LED strips
2pcs of 36 inches (90cm) 54-LED waterproof LED strips
1pc of Control Receiver Box
1pc of remote controller

LED under car kit  

Product Features:

1, Use PVC as enclosure materials, can be arbitrarily curved, high and low temperature resistance, waterproof, etc

2.With a wireless remote control power switch(C key) and change color flashing mode (B button), 7 lamplight color plus 6 kinds of flashing pattern optional,color gradient(D button),increase your nocturnal car fun

3. Any state after the power on(C button), press A button to enter sonic, and press A button again to get back the original pattern

4.can connect the switch power of the brake light and door(single red),can be used as a warning light when open the door or step on the brake light.

5. Made with LED energy saving light source,operating voltage:10V-15V, Maximum power:12W

Installation method

1. Fix the lights to the appropriate location of the car bottom(inside),left,right,front,back,then connect the lead wire with the control box.( Standard connectors)
2. connect the red and black wire of control box to the +/- pole of the car(small lamp power also do),red wire connect the braking power supply or door switch power supply.
3. Use remote control command the switch power and flashing pattern,if no reaction,but the indicator light is on,pls check whether the control box receiving antennas is suspended,or reopen the power supply of control box

Last Update Time:2014-08-29