Meanwell 30W DC-DC Single Output Switching Power Supply 12v switch power supply

ORDER NO.

SDM30-24S5

OUTPUT

DC VOLTAGE

5V

RATED CURRENT

5A

CURRENT RANGE

0 ~ 5A

RATED POWER

25W

RIPPLE & NOISE (max.) Note.2

75mVp-p

VOLTAGE TOLERANCE   Note.3

±2.0% max.

LINE REGULATION   

±1.0%

LOAD REGULATION

±1.0%

TRIM OUTPUT

±13%(Typ.) output voltage

INPUT

RATED DC INPUT

12S: 12VDC         24S: 24VDC         48S: 48VDC

VOLTAGE RANGE

12S: 9.2 ~ 18VDC         24S: 18~ 36VDC         48S: 36~ 72VDC

EFFICIENCY (Typ.)

79%

DC CURRENT

12S:3.6A   24S:2A   48S:1A

IDLE CURRENT

12S:35mA   24S/48S:30mA

PROTECTION

OVERLOAD

Above 105% rated output power

Protection type : Over power limiting, recovers automatically after fault condition is removed

OVER VOLTAGE

5.75 ~ 7.5V

Protection type : Shut off o/p voltage, clamping by zener diode

SHORT CIRCUIT

Protection type : Constant current limiting, recovers automatically after fault condition is removed

FUNCTION

ON/OFF CONTROL

Logic "1" or open: power on         Logic "0" short to Vin-: power off

ENVIRONMENT

WORKING TEMP.

-25~+85°C (Refer to derating curve)

STORAGE TEMP., HUMIDITY

-25~+85°C, 0~95%RH

TEMP. COEFFICIENT

0.03%/°C (0~ 50°C)

SAFETY &

EMC

(Note 6)

SAFETY STANDARDS

I/P-O/P:1.5KVDC

ISOLATION VOLTAGE

I/P-O/P: 100M Ohms / 500VDC / 25°C/ 70% RH

ISOLATION RESISTANCE

Compliance to EN55022 Class A, FCC part 15 Class A without external components

EMC EMISSION

Compliance to EN55022 (CISPR22) Class B

EMC IMMUNITY

Compliance to EN61000-2,3,4,6,8, EN55024, light industry level, criteria A

OTHERS

MTBF

322.4K hrs min. MIL-HDBK-217F(25°C )

DIMENSION

50.8*50.8*16mm (2"*2"*0.63") (L*W*H)

WEIGHT

0.1Kg; 150pcs/15.8Kg/0.97CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 12,24,48VDC input, rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance : includes set up tolerance, line regulation and load regulation.

4. Short circuit not more than 60 second.

5. DC source wires≥ 5cm, an input external al capacitor 47 ~ 100uF is required.

6. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets

EMC directives.