Meanwell 230W Single Output Battery Charger power supply switching/switching power supply manufacturer

MODEL

PB-230-24

OUTPUT

BOOST CHARGE VOLTAGE

28.8V

FLOAT CHARGE VOLTAGE

27.2V

RECOMMENDED BATTERY

CAPACITY(AMP HOURS)  Note 5

24 ~ 80Ah

BATTERY TYPE

Open & Sealed Lead Acid

OUTPUT CURRENT

8A

INPUT

VOLTAGE RANGE  

90 ~ 264VAC         127 ~ 370VDC

FREQUENCY RANGE

47 ~ 63Hz

POWER FACTOR (Typ.)

PF>0.95/230VAC         PF>0.98/115VAC at full load

EFFICIENCY (Typ.)

85.5%

AC CURRENT (Typ.)

3A/115VAC       1.5A/230VAC

INRUSH CURRENT (Typ.)

COLD START 50A

LEAKAGE CURRENT

<3.5mA / 240VAC

PROTECTION

OVERLOAD

90 ~ 110% rated output current

Protection type : Constant current limiting, recovers automatically after fault condition is removed

OVER VOLTAGE

31 ~ 35V

Protection type : Shut down o/p voltage, re-power on to recover

OVER TEMPERATURE

Protection type : Automatically derate charge current until zero

FUNCTION

REMOTE CONTROL (CN105)

Open: Normal work         Short: Stop Charging

FAN CONTROL

RTH3≥50°C Fan ON, ≤45°C Fan OFF (Typ.)

TEMPERATURE SENSE

By NTC

ENVIRONMENT

WORKING TEMP.

-20 ~ +50°C (Refer to derating curve)

WORKING HUMIDITY

20~90% RH non-condensing

STORAGE TEMP., HUMIDITY

-40~+85°C, 10~95%RH

TEMP. COEFFICIENT

±0.03%/°C(0~50°C)

VIBRATION

10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes

SAFETY&EMC

(Note 4)

SAFETY STANDARDS

UL1012(for PB-230-xxAD1 only), TUV EN60950-1 approved

WITHSTAND VOLTAGE

I/P-O/P:3KVAC     I/P-FG:1.5KVAC     O/P-FG:0.5KVAC

ISOLATION RESISTANCE

I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC/25°C/70% RH

EMCEMISSION

Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3

EMC IMMUNITY

Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A

OTHERS

MTBF

244.5Khrs min.    MIL-HDBK-217F (25°C)

DIMENSION

190*96*49mm(L*W*H)

PACKING

1.21Kg; 12pcs/15.5Kg/1.29CUFT

CONNECTOR

PLUG

See page 2 ; Other type available by customer requested

CABLE

See page 2 ; Other type available by customer requested

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance : includes set up tolerance, line regulation and load regulation.

4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meetsEMC directives.

5. This is Mean Well's suggested range. Please consult your battery manufacturer for their suggestions about maximum charging current limitation.