Spice powder horizontal ribbon mixer

Specifications

             Powder horizontal ribbon mixing machine 

 I.General description:

• The Horizontal Ribbon Mixer contains three main parts: U-shape tank,auger and driving parts, with pretty high effect in mixture. The auger is dual structure, outer spiral make the material move from the sides to the center of the tank and the inner screw convey the material from the center to the sides,which is helpful to get convective mixing.
• Our ribbon blender fits for different kinds of powder, granules which accompany with little sticky or cohesive in its composition. This type of machine can also add liquid, spice and paste into powder,besides that, the lid of the tank can be made as open in order to easily cleanup or change parts.

II.Characteristics

 1.With horizontal U-shape tank,a single shaft with two ribbons in symmetric

  distribution.At the top of tank lid,there is an entrance for material,of course we can

  meet the requirements with equipping the device of spraying or adding liquid.

2.No material deposit and without dead angle when mixing.There is a flap dome  valve(pneumatic or manual controller)of the center at the bottom of the tank. The design of the valve is in an arc which assures no material to deposit or exists any dead angle when mixing. With tight interlock and reliable seal,it helps to keep from leaking any material under the circumstance of frequent switch on or off.

3.Durable&Safety: All material are made of Stainless Steel 304.Considering its high quality, these series machine are successfully awarded with CE certification.

4.Optional choice:This type of machine can also be designed to function as cooling or heating. Adding a layer outside the tank to forming into a U-shape hollow interlayer,among which we can put into some particular medium to gain the effect of cooling or heating,usually, injecting cooling water or heated steam,and in some case,it can also use electrical machine for heating.

                                                               disconnecting partial views 

                                                                  Pneumatic  discharge hole

III.Technical parameters

  IV.Qualification & Certification