Video transmitter

1pcs transmitter,1pcs power cable,user's manaul in one pack box.

Video transmitter:

Single fiber 4-path single-direction video 1-path reverse-direction data digital
optical transmitter and receiver(4V+1D)

Specification

1. Fully data no condensation broadcast level transmit

2. No simulation frequency modulation, appearance modulation, amplitude modulation
optical transmitter's across modulation disturb.
3. Support any high exculpation rate video signal, auto compatible, PAL, NTSC, SECAM
audio system.
4. Support video no lose regeneration relay.

5. Support vidio, data, Ethernet, telephone sound side by side transmit.

6. Gigabit fiber transmit technology, large capability, easy upgrade.

7. Fiber WDM/CWDM/DWDM technology.

8. Singlmode, multimode transmit distance 0-100M.

9. Special ASIC design and high speed DSP technology.

10. Advanced self-adapt technology, no have to adjust to use.

11. Fully surface adhibit technology.

12. Industry level design, high dependability.

13. Independent module or rack mount style.

14. Support user handtailor and OEM.

Technical parameter

(Video interfaces)

1. Video input/output impedance

2. BNC 75ohm unbalanced interface

3. Video input/output voltage

4. Typical peal value 1Vpp,maximum 1.5 Vpp

5. Video bandwidth: 8MHZ

6. Video digital bit width: 8 bits/10 bits

7. Differential gain:less than 1%

8. Differentia phase: less than 0.6

9. Signal-to-noise ratio: 67 dB

(Data interface)

1. Physicalinterface Shielding surpassingCat. RJ-45 terminal, industrial wiring terminal

2. RS232 speed: DC-115. 2Kbps

3. RS-422/485 speed: DC-1.2Mbps

4. RS-422/485 distance: 0-1200m

5. RS-422/485protocol: Transparently compatible with RS-485/422 protocol Compatible with I/O on-off volume, alarming data, Manchester Code.

(Ethernet interface)

1. Physical interface:Shielding surpassing-Cat. 5 RJ-45 terminal

2. Supporting protocol: IEEE 802.3 10Base-T 10M, 10/100M Ethernet standards

3. Working mode: Full duplex or half duplex

(Phone interface)

1. Physicalinterface: ShieldingSurpassing-Cat.5 RJ-45 terminal, industrial wiring terminal

2. Voice bandwidth: 4KHZ

3. Working mode: Peer-to-peer hot line,SPC exchange/separating unit mode

(Optical fiber )

1. Physical interface: FC/UPC, ST/UPC,SC/PC

2. Transmission speed: 155Mbps,1.25Gbps

3. Optical fibertype: Singlemodo/multimode optical fiber

4. Transmission distance: Multimode: 0-3km:Singlemode:110km Working temperature: -40~75degree

Note

1. Do not directly watch the optical transmitting interface with naked eyes when
the equipment is electrified so as to avoid hurting.
2. When the equipment is not used, please cover the optical fiber interface with
dirt shroud.
3. Do not connect the interface of power supply of this equipment with the interfaces
of other equipment.