Automatic Burner to replace the oil/gas burner for the boiler

Product Application

I. With long working life

1.The whole furnace is built at one time and take use of the highest quality refractory materials. Which can resist the high temperature at 1800 degree C.

2.Within water jacket design, the circulated water will control the temperature of the furnace and avoid any over heating problem.

3.With smooth furnace design to avoid the coke problem.

II. With higher efficiency and fully load.

1.Because of the one time build for the furnace, there is no extra connection, so it lower down the heat loss.

2.With sufficient insulation, the layout temperature of the burner is the same as the environment.

3.Special boiling and gasifying combustion mode. It takes less than 3 minute from cold mode to final flame.

III. Highly automatic control

1.Computerized system to control automatically from the feeding, lighting, flame adjustable, alarming until the final stop.

2.Based on actual requirement, the flame can changed automatically.

IV. Higher safety

1.Special designed feeding stop valve, which will stop the connection between the silo and the furnace. So there will be no back fire problems.

2.There is alarm system for the over heating, silo empty, etc.

V. Energy saving and environment protection.

1.Compared with gas or diesel burner, the operation cost is only 30-40%.

2.Because of the fully combustion, the final emission is quite lower.

VI. Widely use

1.Replace for the oil/gas burners for the boilers.

2.Directly used for heating and casting industry.

Main Features