2-Way Alarm System

Specifications

2-Way Alarm System, with many operating functions.

The Introduction of the FCS-1 Software and Functions<1> When executing the FCS.EXE software, the computer screen will show followingdiagram:<2> After setting up the No.1 to 33 switches in the software, double click the MODIFYbutton ( button 51 ) for changing the MB function setting.<3> The whole procedure will take about 15-30 seconds, after changing the functions, theMB will beep-beep-beep to show the change is successful.<4> Re-register the RC ( Remote Controller ) with MB to complete the whole procedure.Operating Function Introduction(1) Option of Door motors drive time ( Sec.): (IO Port-Pin15/Pin16, P.9 )central doorlock control timing 0.8 or 3.5 seconds option.(2) Option of Arm, door switch delay time (Sec.): (IO Port-Pin2/Pin6, P.8 ) dome lightdelay 6 or 30 seconds to light up after Arm.(3) Option of Disarm, Dome Light on (Sec.): dome light lights up 15 or 6 second afterDisarm ( depends on models ).(4) Option of Auto door lock by Speed or Foot-brake: to lock car doors automaticallywhen driving ( controlled by speed or brake pedal )(5) Option of the driver of auto door lock speed: (IO Port-Pin 10, P.11) car speed controlwire divided by 1 or 2 . Most car series auto door lock speed is 20 km, divided by 1,for other car series (such as : Nissan series) auto door lock speed might be 40 km,then divided by 2, but the auto door lock speed could be changed to 20km also.(6) Option of siren output : (IO Port-Pin 14, P.10)continuously or discontinuously.(7) Option of Temperature display: in Celsius ()or Fahrenheit ( )(8) Option of Engine-Start, IGNI pre-warm up: (Power Port-Pin 6, P.6) start the engineby remote controller, INGI pre-heat for 4 or 6 Sec.(9) Option of Auto Engine Start by time / temperature: To start the engine at the settingtime or setting temperature.(10) Option of Manual transmission / Auto transmission.(20) Option of Turbo Timer delay time: keep engine running time after startingTurbo-timer ( Setting 0 means disable Turbo-timer function )(21) Option of Turbo timer start after driving more than how many minutes.(22) Option of 2 way RC low battery alert: whether there is a alert when open the car doorafter pressing the disarm key while the RC battery is low.(23) Option of V off ( pin12 ) function as V OFF or Arm active 30 Sec.: ( IO Port -Pin 12,P.12) to be V off output while fuel / electric power is off or be the second ARM-OUToutput ( 30 Sec. )(25) Option of the start motor timing: using RC to remote start the engine or start theengine automatically , the motor start time.(30) Option of Trunk trigger: ( IO Port-Pin4, P11) Trunk input signals , +/- trigger.(31) Option of Hood trigger : ( IO Port-Pin7, P11) Hood input signal, +/- trigger.(32) Option of Brake Pedal : ( IO Port-Pin8, P10)  Foot Brake  input signal, +/- trigger.(33) Option of Hand Brake trigger : ( IO Port-Pin9, P10) Hand Brake input signal, +/-trigger.(51) Modify: to execute the functions change(52) Read Status: to read the Main Board functions setting.(53) Exit: to exit after the functions changed completed.(54) Help: to explain all the functions.