Plastic drip irrigaiton for agriculture

Introduction of plastic drip irrigation

Drip irrigation, also known as trickle irrigation or micro irrigation or localized irrigation, is an 

irrigation method that saves water and fertilizer by allowing water to drip slowly to the roots of 

plants, either onto the soil surface or directly onto the root zone, through a network of valves, 

pipes, tubing, and emitters. It is done through narrowtubes that deliver water directly to the 

base of the plant.

Components (listed in order from water source)

Specifications of plastic drip irrigation

This product is widely applied to agriculture and horticulture irrigation such as crops, flowers, fruit trees irrigation.

• 1000 m per roll
• Flow Rate: Low-Flow
• Turbulent flow through a large water passage to the labyrinth helps reduce clogging.
• Minimum Filtration recommended: 150 mesh.
• Recommended Operating Pressure: 1.0 bar.
• Maximum Operating Pressure: 2.0 bar.
• Minimum Operating Pressure: 0.5 bar.
• UV resistant.
• Use Drip Pipe Barb Fittings.
• Used for the plant or crops in rows.

Pump or pressurized water source about plastic drip irrigation

Water filter(s) or filtration systems: 

sand separator such as Hydro-Cyclone, screen filters, media filters, disc filters

Fertigation systems (Venturi injector) and chemigation equipment (optional)

Main line (larger diameter pipe and pipe fittings)

Usually, PVC pipe and PE pipe are used for main line

Smaller diameter polytube of drip tape(often referred to as "laterals")

Poly fittings and accessories (to make connections)