Symons Cone Crusher In Crusher

Specifications

Symons Cone Crusher In Crusher Start Operation 1, the first start-vacuum system. 2, the lower part of the process after receiving the signal, no-load starting jaw crusher. 3, after the jaw crusher is operating normally, and then start trough feeder to the mine. of Symons Cone Crusher In Crusher

Welded steel jaw crusher welded steel, no large-scale furnace equipment and the like. Relatively easy to spot. But for demanding welding process. And welded steel casing to a second overall warming, in order to ensure the welding flat horizontal force housing. Carefully check the belt is good. If it is found there is insecurity, should be replaced when there is oil on the belt or pulley, apply grease rag and wipe

Features

Symons Cone Crusher In Crusher Long Service Life, Large Feeding Size, Large capacity, Can do Hard Stones, Low Cost Spare Parts,

Symons Cone Crusher In Crusher Operation Notes:

Cut off operations and emergency stop processing 1, ore crusher All cut off must be ruled out before stopping. 2, cut off should be the first stop to the mining system (ie trough feeder). 3, vacuum cleaners and water system before stopping after 5 minutes. 4, the following conditions should an emergency stop: (1) The main shaft bearings or moving the jaw abrupt temperature exceed 80 ℃, the surface phenomenon is touching the back of the bearing can not be sustained for a second time. (2) before or after the thrust plate fracture. (3) belt loose bolts or other transmission parts likely to break when flying wounding. (4) Motor smoke "sweep bore."

Maintenance & Attention

1 large or medium size rigid materials commonly used to crush, impact crusher, such as jaw crusher, roll crusher teeth. 2, strong abrasive materials generally employ mainly crushing, grinding tool surface is smooth. 3. The use of abrasive material impact crusher weak against crushing, grinding, with sharp teeth on crushing tools. 4, small size hard materials commonly used to crush, impact crushing, grinding, surface grinding tools, no teeth, is smooth, such as roll crusher. 5, ductile materials commonly used to cut or quick strikes, such as the hammer crusher. 6, the material should be powdered or mashed using grinding, crushing or impact crusher, such as a ball mill. 7, the use of multi-component materials selection crushed under the impact effect, can also be a variety of force field used in combination.

To Choose a Right Symons Cone Crusher In Crusher

Composite hammer, while having a higher life, but its casting and heat treatment process is complex. For this reason, in recent years developed a variety of low-alloy steel hammer, there 40CrMnSiMoRe been promoting low-alloy steel hammer. 40CrMnSiMoRe steel alloying elements, low production cost, simple process, you can get the required mechanical strength through the appropriate heat treatment. After analysis of the health of the hammer and experiments on the crusher, confirming the performance indicators in line with the kind of material hammer, hammer can be used as a good material. On the plant hammer crusher, 40CrMnSiMoRe high manganese steel hammer and hammer were worn compared. Test Method is mounted on the two rows of hammer crusher, each mounted in a row, with the machine running, test results: 40CrMn-SiMoRe hammerhead run 21d, the high manganese steel hammer run 14d, due to the two hammerhead wear different lengths, so use to measure the actual length of the wear life of more practical.