C-MARK MT5500 Amplifiers

Specifications

C-MARK MT5500 Amplifiers

Specifications

Output Power:

power input jack , fuse, voltage select switch

2Ω/per channel: 1200W

4Ω/per channel: 800W

8Ω/per channel: 550W

Bridged Output Power:

power input jack , fuse, voltage select switch

8Ω / bridged: 1600W

4Ω / bridged: 2000W

RMS Distortion:

1KHz/8 Ω: 0.015%

1KHz/4 Ω: 0.030%

20Hz-20KHz/8 Ω: 0.150%

20Hz-20KHz/4 Ω: 0.200%

Frequency Response:20Hz-20KHz 0.2 dB (8 Ω 1 W)

Damping Factor: > 200 under 8 Ω

S/N: 110 dB

Slew Rate: 50V / μS

Voltage Gain: AV=85

Input Sensitivity: 0.775V under RMS output

Input Impedance:20 KΩ balance input 10KΩ under unbalance input

Controls & Indicators on Front Panel:AC power switch CH1 & CH2 Channel Gain Control

POWER LED: green LED × 2

SIGNAL LED:green LED -30B × 2 yellow LED -60B × 2

CLIP LED: red LED × 2

PROTECT LED: red LED × 2

Jacks and Controls on Back Panel

Signal Input Jack:XLR balance input (1 ground 2 positive 3 negative)

Mode Selection:stereo. dual channel (parallel signal). bridged

Low Frequency Cut: minus 30Hz

Housing ground lift switch selected grounding:

Output Jack: SPEAKON or post

Power:power input jack , fuse, voltage select switch

Cooling system. Two Φ80 fans auto speed high low adjustment according to temperature, thermostat set at 55 degreest.

Amplifier Protection: short circuit protection, subsonic frequency protection, RF protection, clip protection,soft start equipment,overheat and voltage protection.

Overload Protection: no thumps or pops are heard with turn-on /turn-off of speaker System overload automatic power-cut.Filter setting prevents peak overload of woofer.Limiting setting prevents high frequency clip wave and thus avoid teeter damage.

Output circuit types: efficient complementary linear output:

Power voltage: 100 V 120 V select switch, 220 V 240V select switch, 50Hz/60Hz, other voltage available if customised.

Dimension: 88mm × 483mm × 480mm

Weight: 26KG

Note: MT series powers all models of our loudspeakers , preferable for C-MARK AT-series loudspeaker or speaker array.MT1500 fits small size speakers,or drive of tweeter after scaledown,making more pure and more rich sounds.

For extended periods of continual use of the amplifier, it is suggested that load impedance of each channel no less than 4Ω,and for bridged patttern,no less than 8Ω.