Ti-coated sharp rotavator blades

Ti-coated sharp rotavator blades

with segments made of
HSS - DMo5, material
no. 1.3343

tooth form:
roughing tooth and finishing tooth  geometry

The specialists for difficult cutting.

Why so successful:
Special segments are ground radial and tangential. The relief grinding ensures good cutting clearance and avoids side pick-up on the tooth rim.

Solving problems for:

Carbide Circular Saw Blade

Designed for accurate cuts at a higher cutting rate. This blade features the highest quality sawing grade of carbide.

Features

• Highest Quality Sawing Grade of Carbide
• State of The Art Manufacturing Equipment
• Tested and Proven Backing Material
• Unmatched Accuracy and Consistence from Tooth to Tooth
• Pioneers in The Manufacturing and Development of Carbide Blades
• Unmatched Consistency from Blade to Blade

Benefits

• Longest Possible Blade Life
• Higher Cutting Rate
• Minimal or No Warpage During Cutting Operation
• Lowest Cost per Cut in All Types of Material
• Minimal Burr Due to Consistent Chip-Load
• Accurate Cuts With a High Quality Surface Finish

Hints for the right use:

Particularly for cutting thin-walled AL-profiles on miter swingsaws.
The negativ tooth system is insensitive against impacts.
As a result the blade will not be attracted to the workpiece because it offers less resistance against the cutting piece. Especially for anodized profiles.

Used for manual feeding:

For structurals with a wall thickness of:
1 - 3 mm = NW
2 -10 mm = NX

Specifications may change without notice at the sole discretion of Angzi's Engineering Department

TCB-CR: Former ST-3

Circular Saw Blade: TCB-TI

TCB-TI: Former TI-3

Circular Saw Blade: TCB-CB

TCB-CB: Former TA-3

Circular Saw Blade: TCB-SU

TCB-SU: Former TA-SUS

Circular Saw Blade: TCB-PT

TCB-PT

Specifications may change without notice at the sole discretion of Angzi's Engineering Department.

.