Design hot sell smc storage water tank/high quality FRP / fiberglass SMC water tank with food grade resin in water treatment

We are Hebei Sinta Co., Ltd in the North of China,  specializing in the manufactureing and exporting of water tank, mainly include galvanized steel water tank, stainless steel water tank, frp water tank. 

Our frp water tank is mainly exported to world wide friends for their drinking water and undrinking water storage.The capacity can be 1 cubic meter -5000 cubic meter.

Following are our water tank detailed specification: 

♣smc storage water tank application 

1). storage and regulation of living water supply & construction water supply

2). Rainwater Harvesting & Storage

3). Effluent/Acid and alkali solution treatment & Storage

4).Hospital,buildings,building site, school and other place

5). temporary water storage for expansion of the heating system, condensate tank and construction, geological survey, industry, National defense project etc

♣smc storage water tank features

1.  Excellent UV and weather-resistant characteristics; Corrosion resistant; anti-rusted.

2.  High strength and Durability.

3.  Non-leakage.

4.  Excellent Hygienic, good water quality: non-toxic and corrosion from panels and prevent bacteria increasing.

5.  High seismic tolerances; Does not deform or dent.

6.  Low thermal conductivity and excellent thermal insulation.

7.  Easy to clean and maintenance management convenient.

STEP-BY-STEP ASSEMBLY

TANKS FROM 1 TO 10,000M3 (260 – 2,500,000 USG)

Step 1. Install steel footings on leveled concrete foundations.
Step 2. Align GRP panels to be pre-assembled.
Step 3. Place rubber sealant from ready-to-use roll between panels.
Step 4. Connect panels with bolts and nuts.
Step 5. Position bottom panel sections, and finish up base of tank.
Step 6. Position three sides of the tank. 
Step 7. Position and fix roof panels and if required, roof support pipes and plates.
Step 8. Install reinforcement if required.
Step 9. Close up the tank with the fourth side.
Step 10. Finish the internal or external reinforcement.
Step 11. Fill and test.