Outdoor lighting Low frequency induction flood light

Outdoor lighting Low frequency induction flood light 

  Ballast and lamp tube are separated, which is good for heat dissipation.

Features:

1.Aluminum die costing housing with powder coating, which makes it solid, rustproof and durable;
2.High-temp resistant glass shade, pure aluminum reflector with professionally designed angle to maximize lighting reflection efficiency;
3.Gas-tight silicon rubber seal, with IP65;
4.lamp and ballast set features with high power factors, energy saving, stable output and no glares, usually 80W-150W is applied; (optional fixtures to customers' choice)
5.Protection for ballast from short-circuit, open-circuit and defective lamp.
6.Application:Billboards, buildings, parks, pools, parking lots, plazas, tennis courts,etc.

•  Induction lamp is an elcectromagnetic induction fluorescent lamp without filament and electrode. It belongs to the fourth generation of lighting source with LED. It avoids gas emitting by the discharge to decrease the uselife of lighting source, which makes its life increased significantly, reducing maintenance and replacement.
•  Matching the elctronic ballast with high and stable performance,compared to the other light souce, the use life of induction lamp has been significantly increased. Our company's RIZ induction lamp has both above advantages, as well as the application of high-quality fluerescent powder and sophisticated processing technology, high luminous efficiency, and low light decay.

 2. What are the methods of  judging if the lamp and ballast work properly?

•  Instrument detecting

Indicators of detection: voltage, current, power

Problem identifying:

1) Connecting the instrument, switching on the power, if voltage can read, circuit and power can not, it means ballast has been damaged;

2) Connecting the instrument, switching on the power, if the figures displayed of power and current are more larger than the nominal ones and the tube does not light properly, it means the tube has been damaged;

3) Connecting the instrument, switching on the power, if the lamp can displayed properly, however the figure displayed of the instrument is bigger than the rated one by 50% 10 to 30 minutes later, it means the tube has been damaged.

• Interchange detection

Detection method: Preparing a complete set of lamp and ballast to do interchange detection

Problems identifying:

1) Replacing by an intract ballast, switching on the power, if the lamp does not light, it means the tube has been damaged;

2) Replacing by an intract ballast, switching on the power, if the lamp is abnormal after lighting for 30 minutes, it means the tube has been damaged;

3) Replacing by an intract ballast, switching on the power, if the lamp can not start properly, it means the tube has been damaged.