Water Cooled Water Chiller, Screw Water Chiller, CE Chiller

Specifications

LVTE Screw Type Water Cooled Water Chillers

Design Features:

1.Chilled Glycol in/out 12/7°C; cooling water in/out 30/35°C

2.This series of units used in low temperature conditions,45% ethylene glycol to be used as a refrigerant such as antifreeze;

3. Power supply: 3P-380V-50HZ;with voltage allowance ±10%,voltage dif between the phase lines±2%;

4.The data above is for R22, contact us if that for R134a,R407c and other refrigerant need;

5.There may be Changes for improvement without notice, confirm always before your order. 

SYSTEM CONTROL:

1. Imaged system operation chart, showing the temperature of water in/out, the energy level of compressor run, on/off button, run time, alarm etc. And the remote turn on/off function is available. PC remote control is optional.
2. Notice for maintenance is indicated according to the accumulated run time of the compressor.It is convenience to maintenance.
3. The control system will automatically balance the run time for each compressor for mult-compressor unit.

SAFETY PROTECTION:

1. Discharge check value: it prevents the discharged gas from going back after the compressor stops.

2. Phase lack protection: It protects the compressor for over high voltage, voltage deficiency, and phase lack.

3. Direction protection: It protects the compressor from damage resulted from Counter direction run.

4. Oil heater: It heats the oil before the unit start, keep the good lubrication for the unit before it runs.

5. Overheat protection inside the motor of the compressor: It protects the compressor from burning down for too high coil temperature for overload, or abnormal run condition.

6. High&low pressure protection: It protects the compressor and system against extreme run condition and trouble. Freezing protection:It protects the unit form too low temperature of the water out, freezing may occerat some place,resulting in freezing breaking of the evaporator.

7. Water flow protect: It protects the unit from run without water flow.

8. High temperature of chilled water protection: It works to protect the compressor in case that the load is too large,the temperature of chilled water is too high. It may result in compressor failure without this protect in the case.