mud & gas separator oil field

Specifications

1.Usable Range

It was corollary equipment of dedicated that liquid gas Separator and
choke holder header the mostly be used to dispose drilling fluid that
cont gas when kick and the well blowout, and also common use to the
drilling fluid that cont gas and stay in the pit shaft longtime. Bring the
natural gas after purify to out of well site and burning it. The drilling
fluid after purify flow into fluid trough of shaker screen and into
drilling fluid circulating system.

2 . operating principle

liquid gas Separator was should smash it who immerge bleb of drilling
fluid,and then escape gas..Because gravitational effects the drilling
fluid after deaerate will into drain mud cavity, at last expel from drain
tube. more pure compressed air will expelled from outlet-pipe. In the
course of it, the drilling fluid from inlet pipe to hollow axle, and then
the umbrella slice cannon of ambient shake the drilling fluid to shell of
tank that the umbrella slice is circumstance spurt. By bombard vacuum
and the air bubble separator the of action.

3 . structural property

3.1. we adopted cleanup and blowdown to control hi-lo of operating
fluid level for ensure constant the fluid level in Separator and
averted accumulate grit.

3.2. there is gas separation private channel,so the channel clear ,and lift
to effect the purify.

3.3. choose lot of splitting technique combination example the
centrifugation, physics impact separate, vacuum separation etc.

3.4. feed pipe each bend angle section fixed snubber assembly and
mugguard is non-pounding, it can periodic check and replace,
prolong service life of equipment.

3.5. service separator is produced and disposal by special material, it
can avoidancev break product by hydrogen sulphide.

4. Using

 
Liquid gas separator is made of suction assembly, drain pipe
assembly, ladder, pedestal and tank body assembly. Before used the
separator put it on the smoothy earth and connect the suction pipe.
The suction pipe connect used 5″national standard flange, one side
of flange welding 5″ suction line connect the pump and connect the
flange by bolt. Welding a 8″fuller unionat the export of exhaust pipe
and welding it with 8″pipeline. Connect drain pipe with 8flange and
welding the other side of this flange with 8 pipeline.