COUNTERSUNK HEAD ANCHOR DRIVE IN RIVETS

COUNTERSUNK HEAD ANCHOR DRIVE IN RIVETS  All Drive Rivets are just as easy to install, regardless of size or style – just insert in hole and drive pin flush to top of rivet with hammer or pneumatic tool. Pin forces prongs of rivet to flare out below or within fastened materials, creating a strong grip. Leaves a clean non-snagging head when fully installed.

Ideal fastener element to fix sheets and profiles to walls, roofs, building materials and soft materials.

benefit:

• Pull-up action, built into the rivet design, clinches fastened materials together as rivet is attached
• Grip capabilities range from 1.2 mm (.047") to 36.1 mm (1.421") thick
•  Available in six different diameters and numerous lengths to provide the appropriate dimensions for a wide variety of material and dimensional requirements
• Corrosion-resistant aluminum and stainless steel materials provide excellent long-term performance, even in outdoor applications
• Tamper-resistant/tamper-evident designs resist being driven through or drilled out

SGS CERTIFICATION:

CONTACT INFORMATION:

ATTENTION

The information contained in this page message and any accompanying files is or may be confidential.Any use, dissemination, reliance, forwarding, printing or copying of this page or any attached files is unauthorised. This page is subject to copyright. No part of it should be reproduced, adapted or communicated without the written consent of the copyright owner. If you have received this page in error, please advise WUXI RUNTING immediately by  e-mail, or telephone and delete all copies. WUXI RUNGING does not guarantee the accuracy or completeness of any information contained in this page or attached files. Internet communications are not secure. You should scan this message and any attachments for viruses.