standard packing, silver box

IEC61032 Test probe A/B/C/D

Test probe IP1X test probe A

Appliance:

This Test Probe A is the neccessary tool to proceed protecting electric shock test of household and similar electrical appliances.

Purpose:

This Test Probe A is intended to verify the basic protectiion against access to hazardous parts. It's also used to verify the protection against access with the back of the hand.

Conforms to:

Standard IEC61032-1997, IEC60529-2001, GB/T4208-2008 and UL etc.

Technical Parameter:

Test probe IP2X B

1.Appliance:

•  Means of a Test Finger probe that is similar to test probe B of IEC 61032 but having a circular stop face with a diameter of 125 mm instead of the non-circular face, the distance between the tip of the test finger and the stop face being 100 mm.
• These probes simulate human fingers,tools and other items that would be hazardous to come in contact with certain parts of products.

2.Technical Parameter:

Test probe IP3X test probe C 

1.Basic Introduction:

• This IEC61032 Test Pin  conforms to standard requirements of IEC6103 IEC60529 and IEC60065.
• IP3X Test Probe C ( test Probe C)  is the necessary tool to proceed protecting electric shock test of household and similar electrical appliance

2.Application:

v Standard test refers to the joint part can't touch the live parts or close  to the dangerous parts, and 35mm circular baffle can not be enter .

v In the test requirement for preventing access to the hazardous parts,   Test Probe C/D need to be with push force 3±0.3N or 1±0.1N

3.Purpose:

This probe is intended to verify the basic protection against access to 

hazardous parts. It's also used to verify the  protection against access with a tool.

4.Technical Parameter:

Test probe IP4X D

1.Basic information 

v According to: IEC61032:1997/IEC60529:2001 AND UL

v P4X Test Probe D ( Test Probe D) is a necessary appliance for domestic and similar electrical appliance of against electric shock protection test.

2.Application:

v Standard test refers to the joint part can't touch the live parts or approachi to the hazardous parts, 30mm circular baffle cannot enter.

v In the test requirement for preventing from approaching to the hazardous parts, Test Probe D need to exert a thrust 1±0.1N

3.Purpose:

This Test probe D is intended to verify the protection of persons against access to hazardous parts. It’s also used to verify the protection against access with a wire.

4.Technical Parameter:

IPX A/B/C/D without force

IPX A/B/C/D with adjustable force: