clip in remy hair extensions 200g

Specifications

• Before applying your clip in extensions, practice opening and closing the clips by applying pressure to each side of the clip with your thumbs. Using your index fingers or a tail comb, make a clean horizontal part across your scalp about 1 inch from the nape of your neck. Secure your hair that is above the part using a claw clip or hair tie.
• Make sure all clips on the hair weft are in the open position. Always attach the middle clip first. Slide the comb on the clip onto your natural hair and snap shut. Check if the attachment is securely in place. Repeat with the clips on the left and right side of the weft.
• Make sure the weft lies flat along your scalp and feels secure. Release the clipped hair above the part and use a comb to make another horizontal part? To 1 inch above the previously applied extension. Once again, clip your natural hair that is above the part out of the way.
• Attach another weft in the same manner as the first. Remember to always attach the middle clip first.
• Continue making horizontal parts and attaching the extensions as you move up the back of the head.
• Attach the smaller side pieces by making a horizontal part above the ear and attaching the clip in wefts in the same manner.
• Use a mirror to make sure no visible weft is showing. Done! You can now use a hair straightener or curling iron to style your hair extension

• Using a rat tail comb or your own finger, create a parting from the left to the right hairline and section off the hair above this parting using a clip (Picture A).
• Prepare a weft of an appropriate size by snapping the clips open.
• Place the weft right under your parting making sure that there are no gaps (Picture B).
• Catch your hair in each clip and snap in shut. In case of wefts with 3 or 4 clips, the middle clips should be placed first.
• To place the remaining wefts, release all the hair that was clipped out of the way in step 1 (Picture C) and make a parting right above the weft that was just attached. Proceed as described in steps 2-4