MIC-12-1 small yield capacity 800-1500CPH with CE Zhangjiagang factory produce can bottling machine can beverage filling machine

According to customer’s requirement, we will offer our technician for oversea to install and adjust MIC-12-1 small yield capacity 800-1500CPH with CE Zhangjiagang factory produce can bottling machine can beverage filling machine service.

We can also provide our Sales as translator to your site help the installation and Training.
Only to provide the local transportation, accommodation, air tickets (round trip) for Sales will be fine.

This machine need air compressor, 0.8 m3/min 10Kg is enough
This machine can be connected with:
- Water treatment system
- Can depalletizer
- Can rinser
- Can filler-seamer monoblock
- Can turning device
- Can cooling tunnel
- Can turning device
- Liquid level inspector
- Filled can secondary packaging system (shrink-wrapper or carton packaging machine)
- Palletizing system

For Can bottling machine can beverage filling machine question:

First of all, Before we operate Can bottling machine can beverage filling machine , to clearly understand the instructions clearly Can bottling machine can beverage filling machine , first read through the instructions again, adjust and use the familiar Can bottling machine can beverage filling machine , the operating time must be in strict accordance with the instructions to Can bottling machine can beverage filling machine instructions, pay attention to details of the problem, certainly the details determine success or failure

Secondly, In accordance with the instructions on the machine for regular repair and maintenance of the Can bottling machine can beverage filling machine fuselage Oil it, so Can bottling machine can beverage filling machine body as far as possible to protect the reservoir, so that the air can be isolated to avoid Can bottling machine can beverage filling machine rusty, well protected Can bottling machine can beverage filling machine body, and this is a way to extend the life of the 3 in1 filling machine.

Once again, we have to pay attention to hot stand -sealing cloth for cleaning, not retained foreign body in the above, to ensure clean Can bottling machine can beverage filling machine try to avoid the amount of material for a long time into the mouth of the left cause corrosion.

Fourth, We should always check the machine to see contacts at various parts of the machine is good, important to ensure safe use of electricity, no electricity properly to prevent harm.

Fifth, If found faulty , we have to turn off the power , when necessary, by pressing the emergency stop button , and then deflated lift cover, and then close the voltage , check the reason , and troubleshooting.

hank you for your choosing MIC MACHINERY CO., LTD