MIC-12-1 Micmachinery Small Yield Capacity 800-1500CPH With CE Zhangjiagang Factory Produce Beer Tin Can Filling Machine

According to customer’s requirement, we will offer our technician for oversea to install and adjustMIC-12-1 Micmachinery small yield capacity 800-1500CPH with CE Zhangjiagang factory produce beer tin can filling machine service.

We can also provide our Sales as translator to your site help the installation and Training.
Only to provide the local transportation, accommodation, air tickets (round trip) for Sales will be fine.

This machine need air compressor, 0.8 m3/min 10Kg is enough
This machine can be connected with:
- Water treatment system
- Can depalletizer
- Can rinser
- Can filler-seamer monoblock
- Can turning device
- Can cooling tunnel
- Can turning device
- Liquid level inspector
- Filled can secondary packaging system (shrink-wrapper or carton packaging machine)
- Palletizing system

For Beer tin can filling machine question:

First of all, Before we operate Beer tin can filling machine, to clearly understand the instructions clearly Beer tin can filling machine , first read through the instructions again, adjust and use the familiar Beer tin can filling machine , the operating time must be in strict accordance with the instructions to Beer tin can filling machine instructions, pay attention to details of the problem, certainly the details determine success or failure

Secondly, In accordance with the instructions on the machine for regular repair and maintenance of the Beer tin can filling machine fuselage Oil it, so Beer tin can filling machine body as far as possible to protect the reservoir, so that the air can be isolated to avoid Beer tin can filling machine rusty, well protected Beer tin can filling machine body, and this is a way to extend the life of the 2 in1 filling machine.

Once again, we have to pay attention to hot stand -sealing cloth for cleaning, not retained foreign body in the above, to ensure clean Beer tin can filling machine try to avoid the amount of material for a long time into the mouth of the left cause corrosion.

Fourth, We should always check the machine to see contacts at various parts of the machine is good, important to ensure safe use of electricity, no electricity properly to prevent harm.

Fifth, If found faulty , we have to turn off the power , when necessary, by pressing the emergency stop button , and then deflated lift cover, and then close the voltage , check the reason , and troubleshooting.
hank you for your choosing MIC MACHINERY CO., LTD