20-25(t/h) raw mill used in building, metallurgical,electric and chemical industries

Specifications

1. Usage:

Raw material mill is used widely for grinding (both drying and grinding) cement raw material and other materials in building material, metallurgical, electric and chemical industries.

2. Sorts and Features:

a. Common Raw Mill   It is used for small & medium-sized raw materials grinding system which generally is cycle flow system with material separating system outside the mill.

b. Air-swept Mill   The feature of Air-swept mill is short and thick in shell , wide in diameter of inlet & outlet trunnion, large in grate gap area of diaphragms between drying chamber & grinding chamber, no grate plate in mill outlet. Therefore, air speed inside of mill could reach 5m/s due to small resistance and drying capacity is strong since large amount of hot air could get in.

c. Outlet Discharging & Lifting Cycle Mill   Comparing with Air-swept Mill, materials, passing through the drying chamber, are discharged at the outlet of grinding chamber by mechanical way, and then fed into separator by elevator which would return the coarse materials to mill again for cycle grinding.

d. Middle Discharging & Lifting Cycle Mill   From the view of drying, it is the combination of Air-swept Mill & Outlet Discharging & Lifting Cycle Mill; from the view of grinding, it works similar to secondary stage cycle grinding system. At the front end, it has drying chamber with high drying efficiency. Materials are fed from mill inlet; returned materials from separator are fed through mill inlet & mill outlet into rough grinding chamber & fine grinding chamber respectively.