GH-191A Waterproof Solar Powered Wild Animal Repeller Ultrasonic Dog Deterrent

GH-191A  Waterproof Solar Powered Wild Animal Repeller Ultrasonic Dog Deterrent 

1.Specification

2.Detailes

Solar ultrasonic dog deterrent uses ultrasonic to keep unwanted animal out of your garden or yard; 

1.It has a solar pannel which can canvert solar energy into electric.

2.The left side is a speaker can transmit the ultrasonic wave to repel animals.

3.The right side is a PIR sensor, can sense the animals,then the unit will work automatically .

3.Application

1.It can be used in outdoor sunshine place.

2.It has a stick ,can be inserted into the earth.

3.It can repel rat,deer,cat,dog,skunk,etc.

4. To Assemble and Install

1. Unpack the unit completely and confirm that all parts are present.    

2. Connect the repeller head, pole sections, connecting part and ground stake.  

3. Turn power switch to “ON” position.  

4. The PIR repeller is designed to be left ON continuously.  It uses four “AA” size NiCD rechargeable batteries.  

Once turned ON, the LED light and ultrasonic signal will activate for 15 seconds.  Following this activation, 

the unit will move to stand-by  mode.  

5. The unit is now ready for installation.  The location should allow adequate sunlight to keep the batteries fully charged. 

 Be sure that the area needing protection is within the effective range of the repeller.   

6. For best results, keep the repeller head roughly 9-10 inches above ground.  

7. Take care not to stress or break the repeller when installing in hard ground.  It is a good idea to prepare the ground for the 

ground stake to avoid damage to the unit.  

8. When the PIR sensor detects motion, the LED light will flash for 3 seconds and the ultrasonic signal will run for 15 seconds. 

 Following this, the repeller will return to stand-by mode.