white PET Fiberglass Tape

white PET Fiberglass Tape :

Application:
Virtually any commercial or residential application of repairing the cracks and joints or holes of drywall & plasterboard & stucco and the other surface.

Performance include:
Self-adhesive, faster application, no pre-plastering required, easy to apply, resists cracking, do no rot, no blisters or bubbles, more environmentally-friendly job. It won’t tear, shrink, stretch or bubble, while it hides joints, cracks and holes permanently.
 

Specification:
Width(mm): 25,35,48,50,100,150,200,1000
Length(m): 10,20,30,45,90
Mass: 60 or 70g/ter

Mesh:9x9mesh/inch.
Color: white, yellow, blue etc.
Drywall seaming tapes as well as private label and unlabeled tapes.
Each roll is shrink-wrapped.

How to use:
1. Wall must be clean and dry.
2. Center and apply tape over the length of the joint and pressing firmly.
3. Apply a generous first coat of compound over the tape and through the mesh, making sure to completely fill the joint crevice. When the joint has been completely filled, wipe off any excess compound with the drywall knife leaving enough to cover the tape.
4. Let dry completely, then sand slightly.
5. Apply sufficient thin finishing coats to produce a smooth wall surface.
6. Cut of butted boards do not have a tapered edge. Therefore, special care must be taken to assure proper compound penetration of all joints. This may result in slight build-up of compound that will require an increased amount of edge feathering. 

Caution:
Failure to completely fill the joint may result in cracking.
For best results, use a setting-type compound.