2015 New Micro-heated Regeneration Compressed Air Dryer

  Micro-heated Regeneration Compressed Air Dryer

The features of the compressed air dryer

Control system use monolithic microcomputer program to automatic control, reliable and durable capacity. (PLC control can be selected)

With valve switch to automatic show, good human machine interface, easy to operate, it is convenient to maintain

Automatic alarm equipment, if the inlet temperature is too high, inlet pressure is too low or the heating temperature is too high (micro heat-regenerate type), the equipment will alarm

According to actual load and temperature, it can adjust the proportion of regenerate air consumption, save regenerate air energy consumption

It can select cycle switch time, satisfied the require of finished product dew point

A,B  Absorb tower

A1,A2,B1,B2 Switch valve

5 Silencers

3,4,6,7 Check valve

8 Restrictor valve

9 Program controllers

10 Electric heaters

The introduction of the compressed air dryer

Air system

Eliminate channel flow phenomenon

The air distributor of absorb tower adopts large interface stainless steel diffuser and ensure that air flow can through the absorbent floor, avoid channel flow phenomenon, corrosion resistance, durability and never exchange

Install energy saving condition

According to dew point, inlet capacity, pressure, temperature, regenerate air flow can install energy saving condition. It can also depend on air dryer load, adjust regenerate air flow, and reach energy saving efficiency.

Heatless regenerate gas consumption less than 15%

Design of tower structure is rational, store 95%adsorpt heat. It is used to add regenerate air temperature, improve equipment desorbed capacity. Make regeneration of science thoroughly

The air source quality is stable

The direction of dry and regeneration are converse. The drier is not easy to pollute. The air source quality is stable

Micro heat regenerate adsorbed air dryer

Because of heater, decrease gas consumption to 6%

More than 80 cubic meters add reduced two pressure vent valves, one regenerate close valve, extend dryer life. If use molecular sieve as drier, it can reduce pressure dew point

Control system

Heatless: monolithic control (PLC control)

PLC microcomputer system control

Adopt Germany’s Siemens, it can automatic timing,automatic switch,display double tower  work pressure and other function. It can through computer to remote control,alarm. Powerful function, safe and reliable control, system can be upgraded

Adsorb and dry time

Adsorb and dry time adopts pressure dew point control method, ensure air source quality (optional)

Detect exhaust temperature

According to exhaust temperature and humidity to determine regenerate time, in regenerate effect condition, to switch and reduce regenerate gas consumption to minimum. Avoid overtime gas consumption and high efficiency (optional)

Pressure equalization failure alarm  

Two tower use pressure equalization to protect switch. If pressure equalization failure, will alarm (optional)

Trouble signal alarm

All pneumatic valves with position switch, when have trouble, system will send alarm signal (optional)

Air control system

Control air road

Control air road use brass preparation, work life is long, without exchange.(optional)

Compressed heat regenerate type dryer