Industrial-quality Pistol-grip Blasting Gun-foot-pedal Operated Model Nr.:SB350

Sand Blaster  Model Nr.:SB-350

Specification:
Natural rubber/vinyl blast gloves.
Perforated steel flooring-abrasive
Large particle-separating screen
Clean-out door.
Powder conted inside and outside
Air regulator/gauge panel.
14gauge steel legs(16gauge panels)
Eliminating typical suction pick-up tubes and hoses,media metering
Series blast cabinets in an entirely different class from the competition.
External flourescent lighting system.Packed in wooden case.
Overall dimension: 103*90*164cm
Work area: 94.5*60.5*60.5cm
Air pressure range:60PSI~120PSI
Sand capacity: approx 40lb
Abrasive media: silica sand,glass beads,silicon carbide,emery,plastic sand,etc.
Power requirement: 110V,60Hz or 230V,50Hz
Output voltage: 12V

Package details:
Pcs/Ctn: 1
G.W./N.W.: 125/90kgs
Dimension: 128*99*76cm
Q‘TY/20': 28pcs
Q‘TY/40' : 58pcs

WARNING: To reduce the risk of injury, always protect eyes and face with goggles and mask, and hands and arms with heavy work gloves when spraying abrasive materials.

Place the sand blaster induction probe in the sand supply container.

How To Sandblast :

1.    Connect and open the water supply line before starting the pressure washer.

2.    Trigger the gun to relieve the air in the equipment.

3.    Start the pressure washer. See its instruction manual.

4.    Trigger the gun to activate the spray.

CAUTION: Always test spray on a scrap of similar material first! The high pressure spray could damage the surface if the sandblaster is held too close. See step 5 below.

5.    To check the distance you will need to hold the spray nozzle from the surface, start to spray at the scrap of material from a distance of several feet. Gradually move closer, checking frequently to see if the high pressure spray is damaging the surface.

6.    See the application below for the type of sand recommended for your work surface.

Always point the nozzle downward when not spraying. This prevents water from entering the sand supply. If water does get into the sand supply hose, remove the probe from the sand, hold the gun trigger open, and let the hose air dry. Always be sure the sand hose is dry before using.

Keep the sand covered to prevent the overspray from wetting the sand. Do not allow small pieces of the sand bag to fall into the sand supply. A smaller piece could prevent the flow of sand.

Cnjacks' Sand Blaster Models Review

Cnjacks’ Sand Blaster Workshop View