WNMG - TM insert for Steel semi-finishing, Negative angle

Carbide Insert: WNMG

Turning Insert for Steel, Semi-Finishing, Negative, CVD coating

Chip breaker: TM
Useage: For Semi-finishing turning of Steel.
Recommended cutting parameters: ap=0.15-4.5mm; fn=0.2-0.5mm/r
Process: turning, facing and copying
Charactoristic: Better chip removal and good universality. Special bulge close to nose radius and big rake angle make the chipbraker with sharp cutting ability and low cutting force.
Typical parts:ordinary Steel parts.

Recommended grade: CTS251
ISO classification: P20 (P10-P20); M15 (M10-M20)
Color: Black/Yellow
Application recommendation: universal grade, CVD coated on gradient substrate. It is used for finishing to roughing machining of Steel and Steel casting, continuing cutting and interruped cutting.

Recommended grade: CTS101
ISO classification: P15 (P10-P20); K15 (K10-K20)
Color: Black/Yellow
Application recommendation: CVD coating grade, wear-resistance materials coated on gradient sintered substrate with good hardness and toughness. Can bear high temperature. It is used for finishing to roughing machining of Steel and Steel casting, continuing cutting to light interruped cutting.

Optional grade: CTS371
ISO classification: P30 (P25-P40)
Color: Black/Yellow
Application recommendation: CVD coating grade, thick wear-resistant coating on high-strength alloy substrate. Edge line security for interrupted cutting with high metal removal rate. Used for machining Steel and Steel casting in bad conditions.