FW-30M WATER-BASED INTUMESCENT MASTIC

PRODUCT NUMBER

FW-30M

TYPE

The water-based fire retardant coating based on nonflammable resin with special pigment and additives, which will be inflated with the fire or heat to form a fine foam layer. This foam layer can insulate substrates to contact with the fire, therefore consumedly cut down flammability of flammable substrates, and retard the transmission of heat and the expansion of fire to reach effects of fire retardant and cables protection.

USES

Used for the wires and cables

CHARACTERISTICS

1.Veryfast drying and without toxic smoke generating while burning.

2.High build fire retardant coating with high effective fireproof ability.

3.Carbonized foam body can resist high temperature up to 1000℃

4.No contents of asbestos and mineral asbestos.

5. No influence on the electric current capacities of cables.

6. PH value is between 7 and 9 without corrosion to the surface of cables.

FINISH

Flat

COLOR

Grayish white

SPECIFIC GRAVITY

Above   1.2 Kg/L

DRYING TIME(25℃)

Set-to-touch          2 hrs. 

Dry hard      24~48 hrs.  (25 ℃)

OPTIMUM FILM THICKNESS

Wet    500   microns   Dry    270   microns   (per coat)

OVERCOATING INTERVALS

Min.   2 hrs.

NUMBERS OF COATING

Min.   3 times

SUGGESTION OF PAINT FILM

Above   800 microns(DFT)

THEORETICALCOVERAGE

1.92   Kg/ meter square   (2.5 meter square   /Gal)

VOLUME SOLIDS

Above   50%

THINNER

Water

THINNER RATE

Below   5%

NON-VOLATILE CONTENT

Above   66%

STORAGE SHELF LIFE

Minimum 6 months under normal storage conditions.

FIREPROOFTEST

Meet IEEE 383 Part 2.5.4 Fire Test Facility and Procedure.

APPLICATION METHOD

Airless Spray, Brush

NOTE

1.Adhered moisture, grease, rust, dirt or loose paints film on substrate must be cleaned thoroughly.

2.  The product is nonflammable and not poisonous, if contacted with human body or skin that must wash cleanly with water.

3.  Avoid applying the paint in humid exceed 85% RH or temperature low to 5℃.