PLC control eps microbeads machine

eps microbeads machine
export standard packing

PLC control eps microbeads machine

Specification:

Block size: 2270-3000x610x(60-250)mm

High efficiency: make 42 pcs of the panels once(90mm thickness)

Whole precise positioning systems

Can produce different size of sandwich wallboard

PLC control eps microbeads machine  introduction:

Interior/Exterior Wall Panel with EPS core - Green Building Material

The light weight compound sandwich Wall Panel is a kind of light weight energy saving compound board material taking fibre reinforced calcium silicon board or cement calcium silicon board as panel, with cement, EPS, fly ash as fillers and forming by one time compound.

The product can replace construction materials as red brick, clay solid brick, air brick, color-coated steel sandwich board, gypsum block, wire spatial grid structure perlite board, perlite porous board etc. It can widely be apllied to wall materials of various high and low buildings such as: bank, office building, hospital, school, hotel,mall, amusement hall, active barrack, old house reconstruction, residence and workshop.

PLC control eps microbeads machine  

detailed photo:

'

PLC control eps microbeads machine 

productintroduction:

Produced Panel Size: 

Length: 2270mm (2270mm fits the container, can produce from 1500mm to 3000mm long panels)

Width: 610mm

Thickness: 60mm90mm120mm150mm180mm200mm

PLC control eps microbeads machine 

Flow Chart:

Product Installation :

PLC control eps microbeads machine 

trading process:

PLC control eps microbeads machine 

some successful customers:

Q1: How many pieces of panels can one panel forming machine make?

Answer: It depends on the thickness of panels. If the panel thickness is 90mm, one panel forming

machine can make 42 pieces of panels. If the panel thickness is 100mm, one panel forming machine

can make 36 pieces of panels. If the panel thickness is 120mm, one panel forming machine can

make 30 pieces of panels.

Q2: How long is the de-molding time?

Answer: It depends on the cement type and temperature. Normally, if portland cement is used,

the de-molding time is around 5 hours