Automatic stacker for cut to length line

Specifications

Automatic stacker for cut to length line

Technical parameter:

1) Specification:

  *Applicable material:hot-rolled coil, cold-rolled coil, galvanized coils

  *Extension strength:δb≤450Mpa

  *Thickness of material:0.3-3.0mm

  *Width of material:1500(Max)

  *Inner diameter of steel coil:φ508mm, φ610mm

  *Outer diameter of steel coil:φ1500mm(Max)

  *Weight capacity of steel coil:10T(Max)

2)Finished products:

  *Length range:1000-4000mm(according to customer)

  *Length tolerance:L=2m≤±0.5mm

  *Diagonal tolerance:L=2m≤±1mm,

3)Other parameter of equipment:

  *Power source:380V/50Hz/3Ph

  *Linear speed:0-60m/min, 25 pcs / 2m /min

  *Installed capacity:about 70Kw

  *Floor area:about 22mX6m (LXW)

  *Required operator:1 technician, 3 workers

  *Material of roller:42CrMo

Stacking device:

*Length adjusting:min. 1000mm; max. 4000mm.(can be decided by customer)

*Width adjusting:min. 600mm; max. 1500mm.

*Receiving shelf:there are two baffles on the receiving shelf, it join with air cylinder patting device, so that the steel plate can drop parallel.

*Operating of lifter:automatic control device to achieve up and down, it fall down automatically when the height of steel panel increase. Weight capacity is 5T, stacking height is 400mm.

*Discharge device:convey the finished products on the stacker to hoisting area.

Side discharge coil car:

*Equipped with two discharge car, which can guarantee the continuity of production line.

*With motor output electric power.

Function and summarize:discharge car coordinate with hydraulic lifting table to achieve the side discharge by the connection of track. Discharge car equipped with electrical control system, convey the panel at low speed by gearing-down. Stacked panels are conveyed out of the machinery, so that convenient for packing and carrying.